Starting Printing - Stratasys Objet30 User Manual

Objet30 User Guide
want to replace the cartridges of Model and Support material currently
loaded in the printer to avoid the need for replacing them during printing.
For loading material cartridges and replacing empty ones, see "Loading
Model and Support Cartridges" on page 6-5.
For changing the type of material currently loaded, see "Changing the
Printing Material" on page 6-18.
You can monitor printer status by switching the printer interface display. To do
this, click the display toggle button on the printer interface screen.
Figure 6-7 Printer status

Starting Printing

To begin printing:
➢ On the printer interface, click the red button to switch the printer to online
When switching the printer to online mode, a message is displayed if a
maintenance activity is required to ensure optimum printing quality. (See
"Routine Maintenance Schedule" on page 6-31.) Maintenance notifications
can be disabled/enabled from the Options menu.
DOC-34025 Rev. I
Note: When you click Print in GrabCAD Print, a warning message appears if
there is not enough of one or more material.
mode.
The color of the button changes from red to green (see the figure on
page 6-4). If there is a job in the Job Manager queue, it is sent to the printer.
If there is a job in the printing queue, it is sent to the printer.
6 Operating and Maintaining the Printer
6-10