Stratasys Objet30 User Manual page 64

Objet30 User Guide
Fine-Surface Rule
This rule considers models that have one side on which there are fine details
(like the keypad side of a telephone).
➢ The side of the model containing fine details should, when possible, be
Avoid Support-Material Rule
This rule considers models that have large holes or hollows, open on at least
one side (like a pipe or a container).
➢ It may be advantageous to print a model standing up, so Support material
DOC-34025 Rev. I
positioned face-up. This results in a smooth finish.
does not fill the hollow, even though printing the model lying down would be
much faster.
5 Using Objet Studio
5-23