Post-Printing Treatment; Photobleaching For Transparent Models; Storing Models - Stratasys Objet30 User Manual

Objet30 User Guide

Post-Printing Treatment

Post-printing treatment is recommended for models printed with several
special-purpose materials or for special applications. Recommendations for
treating and finishing models after printing are described in the Best Practices
for the desired printing material available on the

Photobleaching for Transparent Models

Models printed with clear materials, such as VeroClear (RGD810) have a slight
yellow tint when removed from the printer. This is especially true for models
printed with a glossy finish. The yellow tint fades naturally over time, but you
can greatly accelerate this process by using a suitable photobleaching
treatment. This involves exposing models to intense light immediately after
printing.
Photobleaching methods and instructions are described in the Best
Practices for the relevant clear material. These are available on the
Transparent materials page on the Stratasys Support
Refer to the Best Practices for:
VeroClear RGD810
l

Storing Models

Models are cured as they are printed, making them safe and stable for a long
time. However, proper storage conditions are necessary to prevent deforming.
• Keep printed models at room temperature and in a low-humidity
environment.
• Do not expose models to direct sunlight and other heat sources.
DOC-34025 Rev. I
7 Handling Printed Models
Stratasys Support Center.
Center.
7-5