Stratasys Objet30 User Manual page 170

Objet30 User Guide
4. When instructed to do so, place the transparency on the build tray—near
5. Make sure that the transparency sheet is lying flat, and tape it to the tray.
6. Close the printer cover.
7. In the wizard screen, select the check box to confirm that the transparency
8. Open the printer and remove the transparency.
DOC-34025 Rev. I
the left and rear edges of the tray, as shown in the following figure.
Figure 6-61 Positioning the transparency on the build tray
sheet is secured to the build tray, and click Next.
When you click Next, the printer prints the head alignment test on the
transparency. When printing is finished, the following screen appears.
Figure 6-62 Head Alignment wizard—steps
The transparency sheet is printed with sets of vertical lines in two rows,
each showing the results from a different print head.
Figure 6-63 Sample head-alignment test
6 Operating and Maintaining the Printer
8–10
6-48