Stratasys Objet30 User Manual page 209

Objet30 User Guide
12. Disconnect the feed tube from the Model material filter, as shown.
Important:
To disconnect the feed tube, hold the fitting at the end of the tube in place
and turn the filter. Otherwise, the feed tube will be twisted and material
might leak.
13. Make sure that the fitting at the end of the feed-tube remains attached to
14. Cover the filter with a cleaning cloth (or paper towels) to absorb material
15. On the new filter, identify the side marked INLET.
16. Attach the inlet side of the new filter to the disconnected tube.
Important:
To attach the filter, hold the fitting at the end of the feed tube in place and
turn the filter. Otherwise, the feed tube will be twisted and material might
leak.
17. Disconnect the old filter from the outlet tube.
DOC-34025 Rev. I
Figure 6-120 Model and Support material filters
the tube. Re-attach it, if necessary.
spillage.
Figure 6-121 Inlet side
6 Operating and Maintaining the Printer
6-87