Cleaning and
Replacing the
Wiper
DOC-13025 Rev. A
A rubber wiper removes excess material from the print heads after the
purge sequence. This is done automatically before each print job, and
performed manually during maintenance tasks. You should clean the
wiper and surrounding area at least once a week. If the wiper is damaged
or worn, replace it.
To inspect and clean the wiper:
1. Prepare—
•
isopropanol (IPA—isopropyl alcohol) or ethanol (ethyl alcohol)
•
disposable cleaning gloves
•
the supplied cleaning cloth or equivalent
•
a spare wiper
2. Start the Wiper Cleaning wizard from the Options menu.
Figure 6-27: Starting the Wiper Cleaning wizard
3. In the opening wizard screen, click
4. Make sure that the build tray is empty, and close the printer cover.
Connex500/350 User Guide
Next
.
6–25