Stratasys Objet30 User Manual page 216

Objet30 User Guide
7. Remove the waste container cover.
8. Unscrew the cap connecting the waste tube to the container.
9. Carefully lift out the container and remove it from the printer.
10. Place cleaning cloths in the waste compartment to absorb any material
11. Extend the materials drawer to the end of its track, as follows:
DOC-34025 Rev. I
Figure 6-132 Removing the waste container cover
leaks.
a. Push the drawer slightly inward.
b. Lift the extension latch and pull out the drawer, all the way.
Figure 6-133 Materials drawer extension latch
6 Operating and Maintaining the Printer
6-94