Stratasys Objet30 User Manual page 160

Objet30 User Guide
4. Make sure that the build tray is empty, and close the printer cover.
5. When the following screen appears, open the cover.
6. Put on the cleaning gloves.
7. Using a generous amount of alcohol on the cleaning cloth, remove any
8. Inspect the wiper.
DOC-34025 Rev. I
Confirm this in the wizard screen, and click Next.
Figure 6-44 Tray and cover confirmation
Figure 6-45 Wiper Cleaning wizard during steps
material remaining on the wiper and the surrounding area.
If the wiper is scratched, torn or worn, or if you cannot clean it completely,
replace it:
6 Operating and Maintaining the Printer
6–9
6-38