Stratasys Objet30 User Manual page 215

Objet30 User Guide
4. Open the materials drawer.
5. Remove the three screws securing the right printer panel and remove the
Caution:
Remove the screws carefully so that they do not fall and scratch the printer
panel.
6. Put on protective gloves.
Warning: Toxic and Corrosive Materials
Prolonged contact with resins could cause skin irritation. Put on protective
gloves before continuing.
DOC-34025 Rev. I
Figure 6-130 Material pumps
panel.
Figure 6-131 Right printer panel removed
6 Operating and Maintaining the Printer
6-93