Stratasys Objet30 User Manual page 82

Objet30 User Guide
2. In the Options dialog box, display the
3. Select Enable Polygon Reduction .
4. Select Polygon Reduction (Percent).
5. Enter the percentage of total polygons to display.
6. Set display options when the object is being moved (Display while changing
7. To save these settings, so that they will be applied every time you place
8. Click Apply to see the results of the settings without closing the dialog box.
Selecting the Entire Object option cancels polygon reduction.
DOC-34025 Rev. I
Figure 5-46 Options dialog box, Display tab
When you click Apply, the display changes.
Note: The setting affects the static display (when the object is not being
moved).
view):
❒ Bounding Box—A box representing the object's maximum dimensions
is displayed.
❒ Adaptive Polygon Reduction—Varying degrees of polygon reduction
are applied, as necessary.
❒ Entire Object—No polygon reduction is applied.
this object on the build tray, click Save Polygon Reduction Data.
5 Using Objet Studio
tab.
Display
5-41