Replacing The Waste-Pump Tubes - Stratasys J850 User Manual

Stratasys J850/J835 User Guide

Replacing the Waste-Pump Tubes

The tubes that pump waste material from the roller waste collector and the
purge unit should be replaced after 1000 hours of use. After this time, a counter
displays a maintenance alert on the printer interface screen.
Figure 4-141 Maintenance alert
You can check when the pump tubes need to be replaced in the Maintenance
Counters interface.
To open the Maintenance Counters interface:
➢ Click on the "Maintenance Required" indicator.
or—
➢ From the Options menu, select Maintenance Counters.
Figure 4-142 Selecting Maintenance Counters from the Options menu.
When the Maintenance Counters screen opens, scroll down to the General
Pumps section.
Figure 4-143 Pump Maintenance Counters
The waste-pump tubes that require replacing are displayed in red.
Note: If the check box on the right is selected, the "Maintenance Required"
indicator appears when that task is due.
DOC-18001 Rev. H
4 Operating and Maintaining the Printer
4-96