Stratasys J4100 User Guide
Replacing the Roller Waste Tubes
As routine maintenance, you should replace the tube in the roller waste pumps
every 700 hours of printing.
Note: Older printers have one roller waste pump; newer installations and
upgraded printers have two pumps.
To replace the roller waste tube:
1. Prepare—
2. Make sure that the printer is either in Standby2 or in Idle mode.
3. Press F8.
DOC-26000 Rev. C
Figure 4-116 Final UV Calibration Wizard screen
❒ two cleaning cloths
®
❒ a Norprene
tube (supplied in the Start-Up Kit)
or—
From the Options menu, select Go to Head Inspection.
The print block moves forward and the build tray lowers.
4 Operating and Maintaining the Printer
4-82