Objet30 User Guide
Figure 6-1 The Objet30 3D Printer
Starting the Printer
Caution
l
l
1. Turn on the main power switch, located at the back of the printer.
DOC-34025 Rev. I
Do not attempt to operate the printer before being trained by an authorized
Stratasys representative.
Observe all safety warnings and follow the safety guidelines described in
Chapter 2.
Figure 6-2 Main power switch and cable
The main power switch turns on the Objet30 printer, which includes the
built-in computer.
6 Operating and Maintaining the Printer
6-3