Stratasys Objet30 User Manual page 218

Objet30 User Guide
4. Disconnect the tubes with their fittings from the ends of the tube extending
If you experience difficulty disconnecting the tube fittings from tubes in the
pump, make a small slit in the tube, as shown.
5. Release the tube latch, as shown.
6. Remove the pump tube with its holder from the pump assembly.
DOC-34025 Rev. I
from the pump.
Figure 6-136 Tubes disconnected from the waste pump
Figure 6-137 Releasing the tube latch
Figure 6-138 Removed tube and tube holder
6 Operating and Maintaining the Printer
6-96