Pattern Test - Stratasys Objet30 User Manual

Objet30 User Guide

Pattern Test

The pattern test is the basic verification of the printer's ability to produce quality
models, since it demonstrates the condition of the nozzles in the print heads.
Make sure, therefore, that you perform this test weekly, and whenever you
suspect a printing problem.
To perform the pattern test:
1. Make sure that the build tray is empty.
2. Prepare a sheet of pink paper, approximately 21 × 14 centimeters in size
3. In the printer, tape the pink paper to the center of the build tray.
4. Press F3, or open the Options menu and select Pattern Test.
5. Click Yes in the Confirm dialog box to begin.
DOC-34025 Rev. I
(8.5 × 5.5 inches)—half of the standard A-4 or Letter size.
Figure 6-48 Selecting Pattern Test
Figure 6-49 Pattern Test confirmation
6 Operating and Maintaining the Printer
6-40