Stratasys Objet30 User Manual page 161

Objet30 User Guide
9. In the wizard screen (see Figure 6-45), confirm that the wiper blade is
10. Remove all tools and cleaning materials from the printer, and close the
11. Confirm this in the wizard screen, and click Next.
12. In the final sceen, click Done to close the wizard.
DOC-34025 Rev. I
a. With the M3 hex (Allen) key, loosen (but do not remove) the screw
securing the wiper.
Figure 6-46 Wiper and excess-material drain
b. Grasp the wiper unit and remove it.
Note: Do not remove the grease.
c. Insert the new wiper, making sure that it is level, and tighten the
securing screw.
clean, and click Next.
cover.
Figure 6-47 Tray and cover confirmation
6 Operating and Maintaining the Printer
6-39