Stratasys Objet30 User Manual page 144

Objet30 User Guide
9. Click Next, and take note of the warning.
Once you start this procedure, you must complete it before you can produce
models with the printer. To perform the procedure at another time, click
Cancel. If you continue (by clicking Next) and you do not complete the
procedure, you must start the Material Replacement wizard again before
producing models.
10. Click Next.
11. When prompted by the wizard screen, remove the material cartridge(s).
DOC-34025 Rev. I
Figure 6-22
Material replacement warning
❒ If the replacement cartridges are already loaded in the materials drawer,
the wizard checks that there is sufficient material to complete the
procedure. Continue with step 7.
❒ If the replacement cartridges are not loaded in the materials drawer, the
wizard prompts you to remove the cartridge(s) from the drawer.
Continue with step 11.
Confirm this in the wizard screen and click Next.
Figure 6-23 Cartridge removal confirmation
6 Operating and Maintaining the Printer
6-22