Objet350 User Guide
Cleaning and Replacing the Wiper
A rubber wiper removes excess material from the print heads after the purge
sequence. This is done automatically before each print job, and performed
manually during maintenance tasks. You should clean the wiper and surrounding
area at least once a week. If the wiper is damaged or worn, replace it.
To inspect and clean the wiper:
1. Prepare—
2. Start the Wiper Cleaning wizard from the Options menu.
3. In the opening wizard screen, click Next.
DOC-17001 Rev. L
❒ 90% isopropanol (IPA—isopropyl alcohol) or ethanol (ethyl alcohol)
❒ disposable cleaning gloves
❒ a supplied cleaning cloth or equivalent
❒ a spare wiper
Figure 6-30 Starting the Wiper Cleaning wizard
6 Operating and Maintaining the Printer
6-32