Material Flush/Fill Wizard - Stratasys Objet30 User Manual

Objet30 User Guide

Material Flush/Fill Wizard

Using the Material Flush/Fill wizard before and after an extended period of
inactivity (more than one week) ensures proper printer maintenance and
quality printing. Each time you run the wizard, you select one of the following
processes:
• draining printing materials and flushing the system with cleaning fluid
• filling the system with fresh printing materials
After more than one week of inactivity, drain and flush the system if this was
not previously done. In this case, run the wizard twice before printing—first,
to drain old printing material and clean the system, and again, to fill it with
fresh material.
To run the Material Flush/Fill wizard:
1. Start Material Flush/Fill wizard from the Options menu.
2. In the opening screen, click Next.
3. Select the required procedure, and click Next.
DOC-34025 Rev. I
Use this process to prepare the printer for a shutdown of more than one
week. This process takes about 60 minutes, and requires four (4) cleaning-
fluid cartridges in the materials drawer.
Use this process to restore the printer to working condition. This process
takes about 30 minutes, and requires two (2) cartridges of Model material
and two (2) cartridges of Support material in the materials drawer.
Figure 6-30 Wizard procedure selection
Note: Before continuing, make sure the required cartridges of material are
available for the procedure selected.
6 Operating and Maintaining the Printer
6-28