Stratasys Objet30 User Manual page 213

Objet30 User Guide
To return the printer to operating mode:
1. Place the waste container in the materials drawer, and attach the cap
Important:
Hold the waste bag with one hand while attaching the waste tube.
Otherwise, the bag will be twisted and the flow of material will be restricted.
2. Place the cover over the waste container, and make sure that the drain tube
Important:
Operating the printer without the waste container cover results in an
inaccurate measurement of the waste weight, which will cause waste to
overflow into the printer.
3. Close the materials drawer.
DOC-34025 Rev. I
connected to the drain tube.
Figure 6-128 Attaching the waste drain tube
is free and not bent.
Figure 6-129 Cover installed on the waste container
6 Operating and Maintaining the Printer
6-91