Stratasys Objet30 User Manual page 167

Objet30 User Guide
6. Pull out the drain-tube release mechanism to raise the tubes out of the
Important: Pull out the release mechanism completely.
7. Support the roller waste collector with your hand under it, and use a 3 mm
8. Pull out the roller waste collector, taking care not to touch or damage the
Warning
The scraper is very sharp! Proceed with caution.
9. Inspect the roller waste collector.
To install the roller waste collector:
1. Carefully insert the roller-waste-collector unit.
DOC-34025 Rev. I
waste collector (see figure below).
Figure 6-55 Freeing the drain tubes from the waste collector
hex (Allen) key to loosen the screws.
Figure 6-56 Roller-waste-collector screws
scraper.
Figure 6-57 Roller waste collector
❒ If the scraper is damaged, replace the entire roller-waste-collector unit.
❒ If the scraper is not damaged, carefully remove any waste from the
waste channel, taking care not to damage the scraper. If necessary, use
90% IPA or ethanol to dissolve residue material in the waste channel
and on the scraper.
Note: The waste collected in this unit contains uncured resin. Dispose of it
in accordance with applicable environmental regulations.
6 Operating and Maintaining the Printer
6-45