Replacing The Odor Filter - Stratasys Objet30 User Manual

Objet30 User Guide

Replacing the Odor Filter

If the printer exhaust is not connected to an external ventilation system, a
built-in activated-carbon filter removes odors from printing materials. This filter
should be replaced regularly (as necessary) to keep your working environment
pleasant.
If the printer exhaust is connected to an external ventilation system, the
odor filter is not needed and should be removed from the printer.
Odor filter removal improves heat expulsion and system cooling.
To replace the odor filter:
1. Locate the filter drawer at the rear of the printer and pull it open.
2. Remove the used filter. (You can push it out from underneath the drawer.)
3. Insert a new filter and close the drawer.
DOC-34025 Rev. I
Figure 6-103 Rear of the Objet30 printer
Figure 6-104 Odor filter in drawer
6 Operating and Maintaining the Printer
6-78