Stratasys Objet30 User Manual page 158

Objet30 User Guide
9. Clean the orifice plates, with a back-and-forth motion (see Figure 6-41).
10. Clean the entire roller surface, by rotating it as you clean.
Use this opportunity to clean the glass lens on the UV lamp using the
supplied sanding sponge.
11. When you have finished cleaning, select the confirmation check boxes in
12. Remove the cleaning materials from the printer and close the cover.
13. Select the confirmation check boxes in the wizard screen and click Next.
DOC-34025 Rev. I
Use the mirror to make sure that you have removed all of the residue
material.
Figure 6-41 Cleaning the heads
the wizard screen (see Figure 6-40) and click Next.
The head-purge cycle begins. When the process is complete, click Done in
the final wizard screen.
Figure 6-42 Final wizard screen
6 Operating and Maintaining the Printer
6-36