Setting The Remote Printer Connection (Client Mode); Job Manager Commands - Stratasys Objet30 User Manual

Objet30 User Guide

Setting the Remote Printer Connection (Client Mode)

When you open Objet Studio for the first time in a client installation, you are
prompted to connect to a server computer that sends jobs to a 3D printer. To
do this, the server computer must be operating and connected to the local
network.
To set (or change) the connection to the server-computer:
1. On the Job Manager ribbon, in the 3D Printer group, click
2. Enter the name of the server computer or its IP address, or click Browse to
3. Click OK.

Job Manager Commands

The Job Manager ribbon has three icon groups:
Icons are enabled or disabled according to their relevancy. For example, since
you cannot stop printing a job that is not being printed, the Stop command is
disabled when the printer is idle.
Job Manager icons are described in the table on the next page.
DOC-34025 Rev. I
find and select it.
Figure 5-87 Printer Server Connection dialog box
❒ 3D Printer
❒ Queue
❒ Job
Figure 5-88 Job Manager ribbon commands
5 Using Objet Studio
.
5-73