Aligning The Print Heads - Stratasys Objet30 User Manual

Objet30 User Guide

Aligning the Print Heads

You should check the alignment of the print heads—
• once a month
• after replacing one or more heads
• if model quality is not acceptable even after cleaning the orifice plate on the
This procedure takes about 20 minutes.
To check the alignment of the print heads:
1. Prepare—
2. Start the Head Alignment wizard from the Options menu.
3. In the wizard screen, select the check box to confirm that the cover is
DOC-34025 Rev. I
bottom of the print block (see "Cleaning the Print Heads and the Roller" on
page 6-34).
❒ a transparency sheet, at least 10.5 × 13 centimeters in size (4.5 × 5.5
inches)—about one-quarter of the standard A-4 or Letter size
❒ any type of adhesive tape, to fasten the transparency sheet to the build
tray
closed, and click Next.
Figure 6-60 Cover confirmation
6 Operating and Maintaining the Printer
6-47