Stratasys Objet30 User Manual page 229

Objet30 User Guide
Caution
Do not use abrasive cleaners or cleaning fluids containing ammonia,
alcohol, acetone, benzine, carbon or tetrachloride. These materials can
cause permanent damage to the surface.
To clean the UV screen:
1. Blow off surface dust.
2. Prepare a 1-percent solution of mild dish-washing soap in water—about
3. Soak a micro-fiber cloth in the solution.
4. Thoroughly wet the surface with the cloth. Do not wipe!
5. Rinse the cloth with clean water.
6. Absorb the solution from the acrylic surface with the cloth, without applying
7. If necessary, repeat to remove any remaining marks, or apply clean water
8. If the surface is still wet, you can dry it with a clean, micro-fiber cloth by
If convenient, you can apply the cleaning solution and water to the acrylic
surfaces with a spray bottle instead of with the cloth.
DOC-34025 Rev. I
Do not wipe the surface to remove dust; this might scratch the surface.
two teaspoons (10 ml) in a liter of water.
Note: While soapy water is effective for cleaning, commercial products are also
available for cleaning acrylic surfaces (for example, Novus
These products give the surface antistatic, smudge and scratch-resistant
properties.
Do not use paper towels, which can cause scratch marks.
pressure.
to rinse the surface.
gently wiping in one direction.
6 Operating and Maintaining the Printer
®
and Brillianize
®
).
6-107