Objet30 User Guide
3. When the following screen appears, open the cover.
Warning: Hot Surface
The print head orifice plates (bottom surface) may be hot. Do not touch
them with your bare hands, and proceed with caution.
4. Put on protective gloves.
5. Loosen the two side screws securing the UV lamp assembly, and place the
DOC-34025 Rev. I
Figure 6-53 Wizard screen that appears when you can begin the
procedure
assembly on top of the print block.
Figure 6-54 UV-lamp-assembly securing screws
6 Operating and Maintaining the Printer
6-44