Preparing The Printer - Stratasys Objet30 User Manual

Objet30 User Guide
In GrabCAD Print, you select the printing mode in the Tray Setting dialog box.
Figure 6-5 Printing mode selection in GrabCAD Print
In Objet Studio, you select the printing mode in the Tray Materials area of the
Tray Settings ribbon.
Figure 6-6 Printing mode selection in Objet Studio

Preparing the Printer

Before beginning to produce models, it is recommended that you check the
current printing quality of the print heads by performing the Pattern Test.
To prepare the printer for producing models:
1. Make sure that the build tray in the printer is empty and clean.
2. If not, lock the build tray and remove cured material with the scraper, and
Caution
Use protective gloves when cleaning the build tray, and be careful of the
sharp edges of the scraper blade.
3. Make sure that there is sufficient Model and Support material loaded, as
DOC-34025 Rev. I
clean the tray thoroughly with a cleaning cloth soaked with 90% alcohol
(IPA or ethanol). To lock the buidl tray
indicated on the printer interface (see the figure on page 6-4). You may
6 Operating and Maintaining the Printer
6-9