Pattern Test
DOC-24333 Rev. A
The pattern test is the basic verification of the printer's ability to produce
quality models, since it demonstrates the condition of the nozzles in the
print heads. Make sure, therefore, that you perform this test weekly, and
whenever you suspect a printing problem.
To perform the pattern test:
1. Make sure that the build tray is empty.
2. Prepare a sheet of pink paper, approximately 21 × 14 centimeters in
size (8.5 × 5.5 inches)—half of the standard A‐4 or Letter size.
3. In the printer, tape the pink paper to the center of the build tray.
4. Press
, or open the Options menu and select
F3
Figure 6-31: Pattern Test confirmation
5. If the build tray is not clear, click
This lowers the build tray, so that models on the tray are not damaged.
Figure 6-32: Build tray (Z) level adjustment
The printer prints a series of lines on the test paper (see next figure).
Lines printed by
support-material
print head
Figure 6-33: Sample Pattern Test
6. Carefully inspect the test paper to see if there are missing lines.
Objet30 User Guide
Pattern Test
in the following dialog box.
No
Lines printed by
model-material
print head
.
6–25