Pattern Test - Stratasys Objet260 User Manual

Objet260 User Guide
10. I n the wizard screen (see Figure 6-32), confirm that the wiper blade is
11. R emove all tools and cleaning materials from the printer, and close the
12. C onfirm this in the wizard screen, and click Next.
13. I n the final sceen, click Done to close the wizard.
Pattern Test
The pattern test is the basic verification of the printer's ability to produce quality
3D prints, since it demonstrates the condition of the nozzles in the print heads.
Make sure, therefore, that you perform this test weekly, and whenever you
suspect a printing problem.
To perform the pattern test:
1. Make sure that the build tray is empty.
2. Prepare a sheet of pink paper, A-4 or Letter size.
3. In the printer, tape the pink paper to the center of the build tray.
DOC-37004 Rev. J
b. Insert the new wiper blade, making sure that it is straight and secured
well on both sides.
clean, and click Next.
cover.
Figure 6-34 Paper positioned for pattern test
6 Operating and Maintaining the Printer
6-34