Pattern Test
DOC-13025 Rev. A
11. Confirm this in the wizard screen, and click
Figure 6-30: Confirmation screen
12. Click
to close the wizard.
Done
The pattern test is the basic verification of the printer's ability to produce
quality models, since it demonstrates the condition of the nozzles in the
print heads. Make sure, therefore, that you perform this test weekly, and
whenever you suspect a printing problem.
To perform the pattern test:
1. Make sure that the build tray is empty.
2. Prepare a sheet of pink paper—A‐4 or Letter size.
3. In the printer, tape the pink paper to the surface left of the build tray.
4. Press
, or open the Options menu and select
F3
Figure 6-31: Pattern Test confirmation
5. If the build tray is not clear, click
This lowers the build tray, so that models on the tray are not damaged.
Figure 6-32: Build tray (Z) level adjustment
The printer prints a series of lines on the test paper (see next figure).
Connex500/350 User Guide
.
Next
Pattern Test
in the following dialog box.
No
.
6–27