MCi Crusader II 1989 Maintenance Manual page 446

Date
1-1-89
Page
13-43
MC-9 MAINTENANCE MANUAL
"'
· '--.• ASSEMBLY OF SHIFT BAR HOUSING
1. Install the housing in a vise with the left side up.
NOTE: Shift bars should be installed from the
front with neutral and shift notches to the
front. Keep bars in the neutral position when
installed.
2. Install the long 1st-reverse shift bar in lowest bore in hous-
ing, installing the shifting yoke and block on bar, long hub of each
to the front (figure 13-168).
......
.,,.--,.
Figure 13-168. Installing 1st-Reverse Shift Bar.
3. Install lock screw in yoke and block. tighten and wire
securely (figure 13-169). ·
Figure 13-169. Installing Lockscrew.
4. Install¾" interlock ball in bore in front boss (fi~ure 13-170).
Figure 13-170. Installing Interlock Ball.
5. Install the 2nd-3rd speed shifting bar in center bore in hous-
ing and install shift yoke. long hub to the rear. At the same time
install interlock pin in bore in neutral notch of bar as notch enters
front boss (figure 13-171) .
\ : ~ ' I I
Figure 13-171. 2nd-3rd Shift Bar Installed.
6. Install yoke lock screw, tighten and wire securely (figure
13-172).
Figure 13-172. Installing Yoke Lockscrew.
,d