MCi Crusader II 1989 Maintenance Manual page 365

Date
1-1-88
Page·_. __
11_-_24 _ _ _
MC-9 MAINTENANCE MANUAL
Figure 11-85. Housing and Sleeve Assembled on Worm Shaft.
35. Maintain pressure on the valve end of the valve housing
to ensure continued engagement of the drive lugs and thrust
bearing package (figure 11-86). While maintaining pressure,
rotate the valve housing to align the poppet adjusting screw
with poppet in the rack piston. Continuing pressure, rotate the
input shaft to bring the valve housing into contact with gear
housing face.
Figure 11-86. Installing Valve Housing Assembly.
36.
Assemble four valve housing bolts (25) into the housing
(1) and tighten to 145-155 ft lbs. (196-210 Nm) torque (figure
11-87).
Figure 11-87.
37. Apply"a generous amount of clean wheel bearing grease
(do not substitute another type of grease) to the bearing race
inside the side cover (42).
CAUTION:
Use
only wheel bearing grHH.
Thia bearing la Haled and will receive no
lubrlcatlon from the hydraullc fluld In the
gHr. Fallure to use wheel bearing grHH
could result In premature steering gear
failure.
NOTE: You will have 41 or 42 rollers to
assemble into the side cover bearing: 41
rollers - BR-970; 42 rollers - BR-970-1. Do
not mix these rollers for the side cover with
the rollers for the trunnion cover side of the
gear housing.
38. Assemble 41 or 42 rollers into the side cover bearing
race. Grease must retain rollers (figure 11-88).
39. Assemble the steel backup washer (43). the new Teflon
backup washer
(44),
and the new two-piece side cover seal (45)
Figure 11-88. Installing Rollers.
into the side cover (42). Assemble two-piece seal so that words
"oil side" are visible (figure 11-89).
CAUTION: The words "oll aide" must be
vlaible once the seal la In place. Otherwise,
the seal wlll not function, which could
result In a l~aa of power steering aaalat.
Figure 11-89. Assembling Washers and Seals.
40. Assemble retaining ring (46) into the ring groove in the
side cover (figure 11-90).
Figure 11-90. Installing Retaining Ring.