MCi Crusader II 1989 Maintenance Manual page 408

Date
1-1-89
Page _ _
13_-s:;___
MC-9 MAINTENANCE MANUAL
d.
Cut lock wire and remove lock screws from each bar just
prior to its removal.
7. Move the top, 4th-5th speed shifting bar to the front and
out of housing, removing shifting yoke from bar (figure 13-12).
Figure 13-12. Top Shift Bar Removal.
8. Move the center. 2nd-3rd speed shifting bar to the front
J out of housing. removing the shifting yoke from bar. As the
neutral notch in bar clears housing ooss. remove the small
interlock pin from bore in neutral notch (figure 13-13).
Figure 13-13. Removing Interlock Pin.
9. Move the bottom. 1st-reverse speed shifting bar to the
front and out of housing, removing the shift yoke and block from
the bar.
10. Two interlock balls will fall from interlock ball opening in
front boss as the last bar is removed (figure 13-14).
Figure 13-14. Released Interlock Balls.