MCi Crusader II 1989 Maintenance Manual page 430

Date
1-1-89
Page ____
13_-_21 _ _
MC-9 MAINTENANCE MANUAL
4. Press the drive gear bearing on shaft. shield to the front
(figure 13-100).
Figure 13-100. Drive Gear Bearing Installation.
5. Clean threads of input shaft and apply Loctite Thread-
ker 277 to threads of new drive gear bearing nut Do not
, e-use old nut.
6. Install the bearing nut on shaft. left hand threaded, tight-
e_ned to 250-300 ft. lbs. (339-407 Nm) torque (figure 13-101) .
........
Figure 13-101. Bearing Nut Installation.
7. Peen the nut into the two milled sIots (figure 13-102).
Figure 13-102. Peening Bearing Nut.
8. Match-mark the drive gear for timing. Mark any two adja-
cent teeth on the drive gear, then mark two adjacent teeth which
are directly opposite the first set marked (figure 13-103).
Figure 13-103. Drive Gear Timing Marks.
9. Remove the retaining ring from drive gear bearing (figure
13-104).
Figure 13-104. Removing Retaining Ring.