MCi Crusader II 1989 Maintenance Manual page 424

Date
1-1-89
Page 13-21
MC-9 MAINTENANCE MANUAL
1.
If not already done. remove front and rear bearings of left
countershaft as previously described.
2. Move either countershaft assembly to the rear, lift front of
shaft to the center of case by the drive and PTO gears and
remove through top of case. Repeat same process for other
countershaft assembly (figure 13-77).
Figure 13-77. Removing Countershaft Assembly.
NOTE: Except for the PTO gears, the left.
and right countershaft assemblies are iden-
tical. Disassembly of each should be per-
formed in the same manner.
3. For models equipped with a countershaft gear retaining
snap ring in groove nearest to drive gear. remove snap ring
from countershaft.
4. Press the drive gear. PTO g_ear, 4th speed gear. and 3rd
speed gear from countershaft. Use caution when pressing
gears as it is necessary to press these gears off in a cluster of
four (figure 13-78).
' i
i
i
:..------
~
.....
...,......
.
~
....
"' : .\
•'ti.&35.
.l .
Figure 13-78. Pressing Gears Off Countershaft.
5. Press the 2nd speed gear from countershaft (figure
13-79).
Figure 13-79. Pressing 2nd Speed Gear Off Countershaft.
6. If necessary, remove the key and roll pin from counter-
shaft (figure 13-80).
Figure 13-80. Removing Key and Roll Pin ••
REMOVAL ANO DISASSEMBLY OF
RIGHT REVERSE IDLER GEAR ASSEMBLY
NOTE: Since the left and right reverse idler
gear assemblies are identical, removal and
disassembly of the Right Reverse Idler
Gear Assembly should be performed in the
same manner as previously described in
this section.
◄