MCi Crusader II 1989 Maintenance Manual page 187

Date 1-1-89 Page
5-5
MC-9 MAINTENANCE MANUAL
Figure 5-9. Compress Retainer.
10.
P!ace· assembly ori an arbor press with a piece of tubing
(see Note) supporting the release sleeve Compress retainer
unt1I drive lugs bottom on flywheel nng and draw three hex nuts
tightly against retainer (figure
5-9).
NOTE: Use a short piece of 2½" or 2 3
1,"
0.D.
(63.5-69.9 mm) tubing to support release
sleeve assembly. Do not support on clutch
release bearing cover rivet threads.
0
-
...
\ '
'
"' '
'
' "' ..>--::::
~
...
~
"
,·"-,~:,
c:,~ - ~ , '
~
---
·~
' . <;::,
.?'Ji"'=---
!
fl
~--- O\:i l I
~
::::::,;::
~
I!!
Figure
5-10.
Remove Wooden Blocks.
11 Raise arbor. Tilt assembly and remove wooden blocks
(figure
5-10)
12. Again support release sleeve on tubing as m Step 10
Remove half ring locks (figure
5-11 ).
Release sleeve and bear•
ing assembly are now free to slide througn retainer toward rear
of clutch
13. To disassemble pressure springs and retainer. com•
press retamerto relieve load on hex nuts. Back off hex nuts and
remove load on pressure springs. Remove pressure spnngs
and spring pivots (figure 5- 12).
14. To complete disassembly. remove the retainer cIIp from
pivot pins. and remove pins and levers ff1gure 5-13)
Figure 5-11. Remove Half Ring Locks.
Figure 5-12. Remove Springs and Pivots.
Figure 5-13. Remove Retainer Clips, Pins and Levers.