17. Clutch Brake; Clutch Linkage Adjustment - MCi Crusader II 1989 Maintenance Manual

Date
1-1-89
Page ____
5 _- 1 _ _ _
MC-9 MAINTENANCE MANUAL
10
1. Driven Disc Assembly
2. Intermediate Plate
3. Driven Disc Assembly - Rear
4. Pressure Plate
5. Spring
6. Ring • Clutch Adjusting
7. Lever
8. Retaining Ring
13. Ring, Flywheel
9. Ring, Sleeve Release
14. Release Sleeve & Bearing Assy.
10. Retainer. Sleeve Release 15. Adjuster Assembly
11. Pivot. Spring
16. Yoke. Clutch Release
12. Pressure Spring 17. Clutch Brake
Figure 5-1. Clutch for 5-Speed Manual Transmission.
CLUTCH
The clutch used with the 5-speed manual transmission is a
15½" dry disc 2-plate model. It is a pull type design with riveted
organic facings on driven discs (except
with
8V92 - ceramic
facings are used). An integral self-adjusting mechanism checks
for plate wear each time the clutch is actuated. Manual adjust-
ment can be made on board by turning the adjusting ring (No. 6.
figure 5-1) which is accessible through the inspection plate
located on the clutch housing.
CLUTCH LINKAGE ADJUSTMENT
With the engine and transmission installed. make the ·final
adjustment of the clutch and linkage as follows.
1. Establish 8.5" (215.9 mm) height between clutch pedal
and coach floor (figure
5·2).
2. Connect all front end linkage as shown.
3. Connect rear linkage and adjust clutch rod ends to main-
tain a 3°-5° (approx.) over center position tor the clutch cross
. shaft levers. Lever travel must be equidistant on either side of
vertical position.