MCi Crusader II 1989 Maintenance Manual page 190

Date 1-1-89.
Page _ _
5 _- 3 _ _
MC-9 MAINTENANCE MANUAL
Figure 5-22. Insert Pivot Pins.
9. Return assembly to workbench and place levers between
adjusting ring bosses with narrow end or "nose" in groove of
release sleeve retainer. Lever fulcrum or raised area of lever
must be facing pressure plate. Move adjusting ring either
clockwise or counterclockwise as necessary to insert pivot
pins. Return adjusting ring to previously set position (figure
5-22).
CAUTION: Spring clips must be installed
so that one spring clip retains two pivot
pins. Clips will only fit in every other open-
ing because of casting interference.
1
u.
Place retainer clip into position and insert pivot pin
through clip hole into adjusting ring and lever hOles until pin
head snaps into position (figure 5-23).
Figure 5-23. Install Retainer Clip.
11. Place pressure plate (8-1)
in
drive slots on flywheel ring.
Check clearance betwee·n driving lugs on pressure plate and
drive slots ,n flywheel ring (C-1 ). Clearance should be .004" to
008" ( 102- 203
mm)
!figure 5a24)
NOTE: Pressure plate was marked in rela-
tion to the flywheel ring when removed.
Reassemble in same slot location.
Figure 5-24. Check Driving Lug Clearance.
12. Install return springs (B-2) as shown. Make sure they are
completely seated in hole (figure 5-25). Springs are to be
hooked from inside of pressure plate first. Then hook opposite
end from outside of flywheel nng.
13. Complete reassembly by turning assembly on pressure
plate side and replace adjusting ring lock (D-2) and bolt assem-
bly (0-3) (figure 5-26).
Figure 5-25. Install Return Springs.
Figure 5-26. Replace Adjusting Ring Lock.