MCi Crusader II 1989 Maintenance Manual page 35

Date
1-1-89
Page 2-7
MC-9 MAINTENANCE MANUAL·
Figure
2-13.
Cotter Key/Lock Plate Removal.
6. Remove the capscrews and washers that hOld the two
bearing caps on the carrier. Each cap is held in position by two
capscrews and washers (Figure 2-14).
Figure
2-14.
Removal of Bearing Cap Capscrews.
7. Remove the bearing caps and bearing adjusting rings
from the carrier (Figure 2-15).
BEARING CAP
Figure 2-1s. Removing Bearing Cap And Adjusting Ring.
8. Safely lift the main differential and ring gear assembly
from the carrier. Put the assembly on a work bench (Figure
2-16).
Figure
2-16.
Lifting Differential And Ring Gear From Carrier.
DISASSEMBLING THE DIFFERENTIAL
AND RING GEAR ASSEMBLY
1 . ff the matching marks on the case halves of the differential
assembly are not visible, mark each case half with a center
punch and hammer. The purpose of the marks is to match the
plain half and flange half correctly when you assemble the
carrieqFigure 2-17).
2. Remove the lock wire. capscrews and washers or bolts.
nuts and washers that hold the case halves together.
WARNING: Wear eye protection. Do not hit
steel parts with a steel hammer. Parts can
break and cause injury.
,4