MCi Crusader II 1989 Maintenance Manual page 414

Date
1-1-89
Page
13-11
MC-9 MAINTENANCE MANUAL
-L Remove capscrew at rear of transmission and remove the
lock plate from slot in the idler shaft (figure 13-36).
Figure 13-36. Removing Lock Plate.
5. Use impact puller to withdraw the idler shatt from case
(figure 13-37).
Figure 13-37. Withdrawing Idler Shaft.
6. Remove the reverse idler gear and the two thrust washers
from case (figure 13-38).
Figure 13-38. Idler Gear Removal.
7. Remove inner ·race of bearing from gear bore (figure
13-39).
8. Press the needle bearing from gear bore.(figure 13-39).
9. Remove plug from idler shaft
if
necessary (figure 13-39).
Figure 13-39. Reverse Idler Gear Disassembled.
REMOVAL QF COUNTERSHAFT BEARINGS
NOTE: Although the bearings of both coun-
tershafts are removed in the same manner,
it is necessary to remove the bearings from
only the right countershaft to remove the
mainshaft assembly from case.
1. Remove capscrews and the rear bearing cover and
gasket from each countershaft (figure 13-40).
Figure 13-40. Removing Bearing Covers.