MCi Crusader II 1989 Maintenance Manual page 429

Date
1-1-89
Page·-___
1J_-_2s _ _
MC-9 MAINTENANCE MANUAL
PARTIAL INSTALLATION OF
COUNTERSHAFT ASSEMBLIES
1. Place the left countershaft assembly with the 47-tooth
PTO gear into position in case. small end through the left rear
countershaft bore. Do not install bearings at this time (figure
13-95).
Figure 13-95. Positioning Left Countershaft.
2. Place the right countershaft assembly with the 45-tooth
PTO gear into position in case. small end through right rear
countershaft bore. Do not install bearings at this time (figure
13-96).
Figure 13-96. Positioning Right Countershaft.
REASSEMBLY AND INSTALLATION OF
MAIN DRIVE GEAR ASSEMBLY
1. Install retaining ring in LO. of drive gear (figure 13-97).
Figure 13-97. Installing Retaining Ring.
2. Install the drive gear on shaft, engaging internal splines of
gear with teeth on shaft, retaining ring of gear toward the front
(figure 13-98).
Figure 13-98. Drive Gear on Shaft.
3. Install the drive gear spacer on shaft and against gear
(figure 13-99).
. Figure 13-99. Installing Spacer.