MCi Crusader II 1989 Maintenance Manual page 435

Date
1-1-89
Page·-. _ _
13_-3_2 _ _
MC-9 MAINTENANCE MANUAL
8. Install spacer in 1st speed gear. engaging external splines of
spacer with clutching teeth of gear (figure 13-122).
~
'
,,·-·
.
'
.
Figure 13-122. Installing Spacer.
9. Remove key and install 1st speed washer, flat side against
spacer (figure 13-123).
Figure 13-123. Installing Washer.
10. Rotate washer to align splines of washer with those of
mainshatt and reinsert key (figure 13-124).
Figure 13-124. Key Re-insertion.
11. Insert two large screwdrivers between 1st and 2nd speed
gears. Apply slight downward pressure on screwdriver handles to
spread gears evenly. Making certain gear hubs are parallel. insert
feeler gauge between hubs (figure 13-125). Correct axial clear-
ance; should be from .005" to .012" (.127-.305 mm). If the
clearance is less than the minimum .005" (9.127 mm) tolerance ..
the washer in the 1st speed gear should be.replaced by a lower
limit washer. This will increase the axial clearance between the
gears. If the clearance checked is greater than the maximum .012"
(.305
mm)
tolerance. a higher limit washer should be installed in
the 1 st speed gear. This would decrease the axial clearance
between the gears.
Figure 13-125. Checking Clearance Between Gears.