MCi Crusader II 1989 Maintenance Manual page 440

Date
1-1-89
Page
13-37
MC-9 MAINTENANCE MANUAL
MPLETION OF RIGHT
_ .1UNTERSHAFT INSTALLATION
NOTE: Left countershaft assembly must
remain in time with main drive gear when
timing right countershaft assembly.
1.
With the right countershaft parallel with mainshaft. mesh the
marked tooth of right countershatt drive gear with the remaining
two marked timing teeth of main drive gear (figure 13-142).
Figure 13-142. Engaging Timing Teeth.
2. Insert countershaft support tool in rear bearing bore (figure
13-143).
> /~-~~':-..
.. ~-
Figure 13-143. Placing Support Tool in Rear Bearing Bore.
3. With timing teeth still in mesh, install countershaft front bear-
ing. Center countersha~ in case bore using a small screwdriver
inserted through bea!ing 1.0. and in bell center or either threaded
hole in end of shaft (figure 13-144).
Figure 13-144. Front Bearing Installation.
4. Install retainer plate. secure with capscrews. and lockwire.
For models otherwise equipped with front bearing retaining snap
nng in groove of countershafl install snap ring (figure 13-145).
~ '
~
~
f)
~ .. ~~-
~
<ft'''~
Figure 13-145. Installing Lockwires.