MCi Crusader II 1989 Maintenance Manual page 445

Date
1-1-89
Page _· __
1_3-4_2 _ _
MC-9 MAINTENANCE MANUAL
REASSEMBLY AND INSTALLATION OF
REAR BEARING COVER ASSEMBLY
1. Install new oil seal in rear bearing cover if original seal was
previously removed. A spring is visible on one side of seal. Install
this side with spring toward front of transmission (figure 13-163).
Figure 13-163. Installing Oil Seal.
2. Install rear bearing cover with new gasket evenly on output
shaft to seat output shaft bearing in cover, aligning oil slot in cover
and gasket with slot in case (figure 13-164).
Figure 13-164. Bearing Cover on Shaft.
3. Install attaching capscrews. tighten evenly and securely
(figure 13-165).
Figure 13-165. Installing Capscrews.
INSTALLING COMPANION FLANGE OR YOKE
1. Lock the mainshaft by engaging two speeds with the sliding
clutch gears (figure 13-166).
Figure 13-166. Locking Mainshaft.
2. Install flange or yoke on output shaft splines and secure with
output shaft nuts. tightening to 400-500
~
lbs. (542-678 Nm) torque
(figure 13-167).
Figure 13-167. Tightening Output Shaft Nut.