MCi Crusader II 1989 Maintenance Manual page 354

Date
1.-1-89 Page
.--1_1_-,_3 _ _
MC-9 MAINTENANCE MANUAL
Figure 11-23. Removing Bolts.
19. Remove the four end cover bolts (30) with a 13/16 inch
socket and remove the four washers {29) (figure 11-23).
20. Remove the end cover (26) (figure 11-24). Some fluid
will drain at this point ·
21. Remove and discard the end cover O-ring (24) from the
end cover (26) (figure 11-25).
Figure 11-24. Removing End Cover.
Figure 11-25. O-rlng Removal.
22. Clean the input shaft with a fine grade emery paper
(figure 11-26).
Figure 11-26. Cleaning Shaft.
23. Loosen the poppet adjusting screw jam nut (21) and the
poppet adjusting screw (20) two turns.
24. Remove the four valve housing bolts (25) with a 13/ 16
inch socket (figure 11-27).
25. Remove the valve housing (19) (figure 11-28). Some
fluid will drain.
NOTE: The valve sleeve (Sb) will probably
remain In the valve housing.
CAUTION: Do not remove . the drive rtng
{Sc} from the worm shaft (Sa) or attempt to
distort the tangs which hold the drive ring
in place on the worm shaft. Doing either
will alter the valve timing and could
cauM
the coach to
pull
to one aide after the steer-
Ing gear la Installed.
Figure 11-27. Housing Bolt Removal.
-
Figure 11-28. Valve Housing Removal.
26. Remove the valve sleeve (5b) from the valve housing
(19) (figure 11-29).
Figure 11-29. Removing the Valve Sleeve.
"""'