MCi Crusader II 1989 Maintenance Manual page 12

Date
1-1-89 Page ---'-_
1
_-s _ _
MC-9 MAINTENANCE MANUAL
Figure 1-9. Removing Steering Knuckle From Axle.
STEERING KNUCKLE SEALS
Inspect the grease seals for tears. rips and deterioration. Do
not remove the seals from the steering knuckle unless replace-
ment is necessary or if the knuckle is to be rebushed. If seal is to
be removed. pry it out with a screwdriver. Refer to figure 1-10.
Figure 1-10. Grease Seal Removal.
If seal is being installed in a knuckle which has bronze
bushings:
1. Place steering knuckle bottom side up in a vise equipped
with soft metal protectors. Position upper knuckle boss (top end
down) between jaws of vise and lock securely.
NOTE: Seals must be oriented as shown.
Reversal of a seal
will
prevent purging of
grease.
2. With the top end of the knuckle held firmly in this position.
place the seal over the knuckle counterbore. with the rubber lip
facing up. ·
3. Using a suitable sleeve and a bronze drift. tap the seal into
the knuckle until it bottoms against the bushing or counterbore.
See figure 1-11.
Figure 1-11. Installation of Grease Seal
(Bronze or "Easy Steer" Bushed Knuckles).
I
~