Complete Hardware Guide for EX3300 Ethernet Switches
Table 10: Status LED on the Uplink Ports in EX3300 Switches
LED
Status
Related
Documentation
Management Port LEDs in EX3300 Switches
20
LCD Indicator
LED: SPD
LED: ADM
LED: DPX
LED: POE
Front Panel of an EX3300 Switch on page 6
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
Configuring Gigabit Ethernet Interfaces (J-Web Procedure)
The management port on the rear panel of an EX3300 switch has two LEDs that indicate
link/activity and port status (see
Figure 9: LEDs on the Management Port on an EX3300 Switch
Link/Activity
LED
Table 11 on page 21
describes the Link/Activity LED.
State and Description
Indicates the speed.
The status indicators are:
Unlit—10/100 Mbps
Blinking—1000 Mbps
On steadily—10 Gbps
Indicates the administrative status. The status indicators are:
On steadily—Port is administratively enabled.
Off—Port is administratively disabled.
Indicates the duplex mode.
The uplink ports are always set to full-duplex; therefore, the
LED for uplink ports is always green.
Indicates the PoE status.
PoE is not enabled on uplink ports; therefore, the LED for uplink
ports is always unlit.
Figure 9 on page
20).
Status
LED
Copyright © 2015, Juniper Networks, Inc.