Revert To The Factory-Default Configuration Using The Factory Reset/Port Mode Button - Juniper EX4100 Hardware Manual

run. (The EZsetup script is available only on fixed configuration switches, it is not available on modular
switches.)
NOTE: The load factory-default command by itself is not supported on EX3300, EX4200, EX4500,
and EX4550 switches configured in a Virtual Chassis.
To revert to the factory-default configuration by using the load factory-default command:
NOTE: If you use this procedure, you must delete the system commit factory settings, set the
root password, and commit the configuration. These steps are not required when you revert to
the factory-default configuration by using request system zeroize. Also, the auto-image-upgrade
statement is not added to the configuration when you use this procedure; it
configuration when you use request system zeroize.
1. [edit] user@switch# load factory-default
2. [edit] user@switch# delete system commit factory-settings
3. [edit] user@switch# set system root-authentication plain-text-password
4. [edit] user@switch# commit
5. Check the member ID and primary-role priority with the
see whether there are remaining settings for uplink VCPs by using the
command.
6. Check for remaining settings for uplink VCPs by using the
Revert to the Factory-Default Configuration Using the Factory Reset/Port Mode
button
To set the switches to the factory-default configuration, use the Factory Reset/Mode button located on
the far right side of the front panel.
NOTE: To revert a member switch of a Virtual Chassis to the factory-default configuration,
disconnect the cables connected to the Virtual Chassis ports (VCPs). You disconnect the cables
to prevent any effect on Virtual Chassis configuration parameters (such as member ID, primary-
role priority, and setting of VCP uplinks) on other members (see
To revert to the factory-default configuration by using the Factory Reset/Mode button:
is added to the
command. and check to
show virtual-chassis
show virtual-chassis vc-port
show virtual-chassis vc-port
Disconnect a Fiber-Optic Cable
177
command.
).