Table of Contents
Advertisement
EX2300-C and EX2300 Switches Hardware Guide
Reverting to the Factory-Default Configuration by Using the Factory Reset/Mode button on
EX2300 and EX3400 Switches
Related
Documentation
190
[edit]
3.
user@switch# set system root-authentication plain-text-password
[edit]
4.
user@switch# commit
Check the member ID and mastership priority with the
5.
and check to see whether there are remaining settings for uplink VCPs by using the
show virtual-chassis vc-port
To set the EX2300, EX2300-C, and EX3400 switches to the factory-default configuration,
use the Factory Reset/Mode button located on the far right side of the front panel.
NOTE:
To revert a member switch of a Virtual Chassis to the factory-default
configuration, disconnect the cables connected to the VCPs to avoid affecting
Virtual Chassis configuration parameters (member ID, mastership priority,
and setting of VCP uplinks) on other members. See
Fiber-Optic Cable from a Device" on page
To revert to the factory-default configuration by using the Factory Reset/Mode button:
Press the Factory Reset/Mode button for 10 seconds. The switch transitions into
1.
factory-default configuration and the console displays
configuration
.
Press the Factory Reset/Mode button for 10 more seconds. The switch transitions
2.
into initial setup mode and the console displays
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 179
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 182
Configuring an EX4200, EX4500, or EX4550 Virtual Chassis (CLI Procedure)
Understanding Configuration Files for EX Series Switches
For more information about the load factory-default command, see Junos OS CLI User
Guide
.
show virtual-chassis
command.
200.
committing ezsetup config
Copyright © 2017, Juniper Networks, Inc.
command
"Disconnecting a
committing factory default
.
Hide quick links:
Advertisement
Table of Contents
